Steve Saunders Goldwing Forums

Steve Saunders Goldwing Forums (https://www.goldwingfacts.com/forums/)
-   Reference and FAQ Forum (https://www.goldwingfacts.com/forums/10-reference-faq-forum/)
-   -   How to change GL1500 gear shifter shaft oil seal. With pictures. (https://www.goldwingfacts.com/forums/10-reference-faq-forum/340200-how-change-gl1500-gear-shifter-shaft-oil-seal-pictures.html)

SuzukiStorm 01-12-2010 06:34 AM

imported post
 
1 Attachment(s)
How to change gear spindle shaft oil seal.
Hi. I have found that left side of the engine is wet. After investigation I have understood that the spindle shaft oil seal is worn. Also nicks on the shaft are worn and it haв a free play. Below is an info, how to change this ill-starred oil seal.

1. Get the bike on the right side on the guard ( I have used a pieces of wood under the guards).
2. Uninstall left lower fairings (see the manual because I was lazy to make some photos)

SuzukiStorm 01-12-2010 06:35 AM

imported post
 
1 Attachment(s)
3. Unscrew six nuts on the studs.

SuzukiStorm 01-12-2010 06:35 AM

imported post
 
1 Attachment(s)
4. Unscrew the bolt on the exhaust end. Make the clamp free.

SuzukiStorm 01-12-2010 06:35 AM

imported post
 
1 Attachment(s)
5. Unscrew low fairing bolt under frame.

SuzukiStorm 01-12-2010 06:36 AM

imported post
 
1 Attachment(s)
6. Try to unscrew the shaft, if not u will do it a bit later.

SuzukiStorm 01-12-2010 06:36 AM

imported post
 
1 Attachment(s)
7. Uninstall engine guard.

SuzukiStorm 01-12-2010 06:37 AM

imported post
 
1 Attachment(s)
8. Pull the exhaust down and forward. Now u should to unscrew the shaft bolt and disassembly it. In my case the shaft had looseness and a bit worn nicks. I decided to cut the clearance by disc cutter; therefore I would squeeze the shaft on the spindle shaft.

SuzukiStorm 01-12-2010 06:37 AM

imported post
 
1 Attachment(s)
.

SuzukiStorm 01-12-2010 06:38 AM

imported post
 
1 Attachment(s)
.

SuzukiStorm 01-12-2010 06:39 AM

imported post
 
1 Attachment(s)
9. I have washed the engine and screwed the screw in oil seal, it is the most easy way, or u can pluck out it by screwdriver, as me :)


All times are GMT -5. The time now is 12:30 PM.

Powered by vBulletin® Copyright ©2000 - 2019, Jelsoft Enterprises Ltd.

User Alert System provided by Advanced User Tagging (Pro) - vBulletin Mods & Addons Copyright © 2019 DragonByte Technologies Ltd.
Shoutbox provided by vBShout v6.2.1 (Lite) - vBulletin Mods & Addons Copyright © 2019 DragonByte Technologies Ltd. Runs best on HiVelocity Hosting.

 
For the best viewing experience please update your browser to Google Chrome