Steve Saunders Goldwing Forums - View Single Post - Lowering the GL1000

View Single Post
post #3 of (permalink) Old 11-05-2011, 10:19 AM Thread Starter
zimco
Member
 
zimco's Avatar
 
Join Date: Oct 2011
Location: Hilton, New York, USA
Posts: 156
Send a message via AIM to zimco
Post imported post

I also must state here that I am not a welder, some of the welds may appear to be bubblegum, Once I get the whole project tacked and stripped I will go back and grind, & plate the bad welds.

I do much better when I can get at the welding on a flat level surface and not laying on the ground.

You may also notice as I go on I tend to overkill the project, I have never had anything I have welded come apart after I am finished with it.

This is the right rear tacked together, with a gusset I was fitting. The top bar is welded on both sides the bottom is only welded on the top.
Attached Images
File Type: jpg 1975 GL1000 Chop 11:02:11 - 008.jpg (57.9 KB, 1412 views)

1967-69 Vietnam Vet
Life Member DAV
Patriot Guard Rider

1996 GL1500 SE Trike
1980 GL1100 Naked and Low
(1) 1975 GL1000 (being lowered)
(5) 1975 - 79 GL1000 Parts bikes

"Never try to teach a pig to sing
It wastes your time and it annoys the pig."

"You can also follow me on my blog Zimco\'s Garage"


To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts.
zimco is offline  
 
 
For the best viewing experience please update your browser to Google Chrome