Steve Saunders Goldwing Forums - View Single Post - heating and molding lexan

View Single Post
post #4 of (permalink) Old 02-10-2012, 10:20 PM
blackknytecnc
Senior Member
 
blackknytecnc's Avatar
 
Join Date: Apr 2011
Location: Maricopa, Arizona, USA
Year: 1985
Model: 1985 GL1200 LTD
Posts: 2,722
Garage
Post imported post

You could still try the oven (again, depending on what you're doing), but it would have to be set pretty much as high as it would go, and you'd have to be dang careful to have it in just long enough to get soft, because that stuff browns easier than you'd think.

Slow, low heat distorts it, high fast heat browns it if it gets too hot, but if don't get hot enough it'll start to bend then shatter like a cheap plate.

1985 LTD.... 121,000 miles and counting

"Democracy is two wolves and a lamb voting on what to have for lunch. Liberty is a well-armed lamb contesting the vote." _ Ben Franklin

"Oops, that wasn't suppose to happen" _ Kevin (me)
blackknytecnc is offline  
 
 
For the best viewing experience please update your browser to Google Chrome