Steve Saunders Goldwing Forums

Steve Saunders Goldwing Forums (https://www.goldwingfacts.com/forums/)
-   Goldwing Technical Forum (https://www.goldwingfacts.com/forums/2-goldwing-technical-forum/)
-   -   Persistant Tri-Magnum Engine Problem... (https://www.goldwingfacts.com/forums/2-goldwing-technical-forum/341159-persistant-tri-magnum-engine-problem.html)

m_motorsports 02-02-2010 11:11 PM

imported post
 
You guys are brilliant, so here's a new challenge: The engine on my '88 GL 1500 runs, then intermittently stops. A tic on the starter (without the starter even engaging) instantly re-starts it... It's like the starter circuit re-sets a relay. Since this bike is mounted in a Tri-Magnum 3-wheel car, all interlocks (kickstand, clutch switches,etc) have been bypassed. I have also replaced the Bank Angle Sensor, and hot-wired 12 volts directly to the ECU (Black wire with white stripe). This thread is also listed under: "Honda GL 1500" Engine Stops... Any ideas will be appreciated - Not sure where to go from here... Perhaps replacing relays??

SETHAN12 02-02-2010 11:33 PM

imported post
 
Could be a lot of things but the first most inexpensive thing that you could do would be to check your grounds. I find that most electrical problems start here.





I am definitely not brilliant:Dbut some guys on this site really are. Hope they answer soon for you.

Hatchetman 02-03-2010 12:13 AM

imported post
 
how often does this happen? is it an every day thing, every few minutes?? Have you ever had your kill switch controls apart to change handle bars etc? Are you able to willgl suspect wiring like the kill switch wire for instance & make it quit?

m_motorsports 02-03-2010 07:22 AM

imported post
 
It's very intermittent - Seems to be getting worse, especially on cold days. Now it happens every 20 seconds. I'll try to locate the kill switch wire and isolate it. I'll also check grounds.

Please keep your suggestion coming - I'm getting desperate. The Tri-Magnum is Really Fun when it's running...

CaptainMidnight85 02-03-2010 08:17 AM

imported post
 
1891 Attachment(s)
Did you ever check the ignition switch controls up front?

m_motorsports 02-03-2010 02:38 PM

imported post
 
Nope- I figured that hot-wiring the ICU would by-pass the switch. I'm going to check relays , connectors, and fuses today...


All times are GMT -5. The time now is 04:23 AM.

Powered by vBulletin® Copyright ©2000 - 2019, Jelsoft Enterprises Ltd.

User Alert System provided by Advanced User Tagging (Pro) - vBulletin Mods & Addons Copyright © 2019 DragonByte Technologies Ltd.
Shoutbox provided by vBShout v6.2.1 (Lite) - vBulletin Mods & Addons Copyright © 2019 DragonByte Technologies Ltd. Runs best on HiVelocity Hosting.

 
For the best viewing experience please update your browser to Google Chrome