Steve Saunders Goldwing Forums

Steve Saunders Goldwing Forums (https://www.goldwingfacts.com/forums/)
-   Goldwing Technical Forum (https://www.goldwingfacts.com/forums/2-goldwing-technical-forum/)
-   -   Spare part lying around after changing GL1100 rear tire? (https://www.goldwingfacts.com/forums/2-goldwing-technical-forum/383535-spare-part-lying-around-after-changing-gl1100-rear-tire.html)

jshfchtr 03-04-2012 09:39 PM

imported post
 
I had some new rubber put one of my spare rims and swap it in this weekend, however when I was cleaning up the garage I found a part lying around that I can't recall where it came from... Its a metal tube greased on the outside. Its roughly 4 inches long by 3/4 inch wide and about an eight of an inch thick. I pulled the tire and laid it down on some cardboard to pull the final drive and change over the gear in the rim. This is where I found the extra part so it must have fallen out of either the gear in the rim or the final drive. Can anyone help me identify this part?

Sorry for just the description, I don't have a camera anywhere in the house.

DriverRider 03-04-2012 09:46 PM

imported post
 
Seems like it would be a spacer between the wheel bearings. Just a guess.:smallpopcorn:

JD

busdriver 03-04-2012 09:49 PM

imported post
 
Yup sounds like the spacer tube.
Fits into the final drive before you fit the wheel.

sandiegobrass 03-04-2012 09:51 PM

imported post
 
1 Attachment(s)
This "collar"???

Kimswang 03-04-2012 09:53 PM

imported post
 
Oooopsss

DriverRider 03-04-2012 09:56 PM

imported post
 
You better get out to the garage and loosen that axle nut now.

JD

jshfchtr 03-04-2012 10:21 PM

imported post
 
Ahh.... Sounds like I'll be pulling the final drive again then :sadguy:

Will there be any ill affects from tightening the axle nut without the spacer in? I torque it down to 65 ft-lbs

Thanks for the quick responses

newday777 03-04-2012 10:46 PM

imported post
 
Did you ride it that way? Did you spin the wheel after torquing, to check it?

jshfchtr 03-04-2012 10:49 PM

imported post
 
No, it hasn't left the center stand yet.

wilf 03-04-2012 10:56 PM

imported post
 
hopefully no damage but get that apart soon.Good thing you found it as it would have been a big prolemif you tried to ride it lie that pehaps you have damaged the bearings as they mus have taken all the clamping load directly on the rollers and races
Wilf


All times are GMT -5. The time now is 09:46 AM.

Powered by vBulletin® Copyright ©2000 - 2019, Jelsoft Enterprises Ltd.

User Alert System provided by Advanced User Tagging (Pro) - vBulletin Mods & Addons Copyright © 2019 DragonByte Technologies Ltd.
Shoutbox provided by vBShout v6.2.1 (Lite) - vBulletin Mods & Addons Copyright © 2019 DragonByte Technologies Ltd. Runs best on HiVelocity Hosting.

 
For the best viewing experience please update your browser to Google Chrome