Steve Saunders Goldwing Forums banner

Brakes bleeding

3K views 5 replies 4 participants last post by  redwing52 
#1 ·
BRAKE BLEEDING SEQUENCE

1) Using the Front Brake Lever - Front Right caliper Upper bleed nipple
2) Using the Front Brake Lever - Front Left caliper Lower bleed nipple
3) Using the Rear Brake Pedal - Front Left caliper Upper bleed nipple
4) Using the Rear Brake Pedal - Front Right caliper Lower bleed nipple
5) Using the Rear Brake Pedal - Rear caliper Lower bleed nipple
6) Using the Rear Brake Pedal - Anti Dive plunger
7) Using the Rear Brake Pedal - Rear caliper Upper bleed nipple

If you feel there might still be air in the system, these further steps can be done, but are optional.

8: Pressure bleeding the lower Junction block. (Upper left side of frame sitting on bike).Follow rubber hose from Secondary master cyl to the Junction block.

9: Pressure Bleed the top Banjo bolt on the Secondary Master Cyl. (To be sure the air bubble is completely out)

Copied from Goldwing Docs
 
See less See more
#4 ·
Done as per above formula. I used a vac pump for all but the last two. I couldn't get any liquid out of the anti dive till I pressed the foot pedal. On the upper rear bleeder was difficult to work the vac pump ,wrench and vac hose so I opted to use the foot pedal.
My wife was the helper.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top