Steve Saunders Goldwing Forums - View Single Post - Crankshaft/ timing belt gears

View Single Post
post #12 of (permalink) Old 07-13-2017, 11:13 AM Thread Starter
Wilcoy02
Alaskan Explorer on a Valk
 
Wilcoy02's Avatar
 
Join Date: Aug 2010
Location: Marengo, Ohio, USA
Year: 1983
Make: Honda
Model: GL1100
Posts: 562
Garage
Send a message via AIM to Wilcoy02
The shaft I am having troubles with is the center shaft. Where the 2 belt gears are located. The rear one is where I have 1/8 inch slop. This is causing the motor to have a knock when running. I believe because the belt is 1/2 tooth off due to the slop.


These are not aluminum as a magnet does attach to the center gears.




So is spot welding feasible?
Is there a key for these two belt gears?
Wilcoy02 is offline  
 
 
For the best viewing experience please update your browser to Google Chrome