Steve Saunders Goldwing Forums - View Single Post - 1997 Goldwing GL1500 Jerks under 2,000 RPM

View Single Post
post #39 of (permalink) Old 06-10-2018, 08:13 PM
DaveO430
mod-erator
 
DaveO430's Avatar
 
Join Date: Nov 2007
Location: Amity, Arkansas, USA
Model: 2010 GL1800
Posts: 24,194
Garage
Quote:
Originally Posted by GoldwingA1500 View Post
That was a slight problem in setting the float height. In the manual, one section stated 7mm, while another said 8mm. I set them at 7mm which might be a bit short. Fortunately I do not see any fuel draining from the overflow line, but I do have a mind to remove the carbs again and closely inspect the CV boots for any possible hole or tear that I may have missed last year. I will also reset the float height to 8mm. Which is it? 7mm or 8mm?

Joe

If it's too lean at 7mm you sure don't want to go to 8mm. You were asked the method you used to set the floats. Did you have the carbs upside down or just let the float rest on the pin.

With no God over the state, the state then becomes not the defender of liberty but the definer of liberty.


NRA endowment life member
Wild Rhino Arkansas chapter
2010 1800 pearl yellow

If I disagree with you it's simply because you're wrong.
DaveO430 is online now  
 
 
For the best viewing experience please update your browser to Google Chrome