Steve Saunders Goldwing Forums - Search Results

Advanced Search
Showing results 1 to 25 of 500
Search took 0.05 seconds.
Search: Posts Made By: Nightrider1
Forum: Goldwing Technical Forum   06-13-2016, 12:57 PM
Replies: 14
Views: 987
Posted By Nightrider1
Which wires do you swap and where are they...

Which wires do you swap and where are they located at?
Forum: General Motorcycle Discussion Forum   06-08-2016, 07:42 PM
Replies: 5
Views: 410
Posted By Nightrider1
You are very lucky. Glad you found it.

You are very lucky. Glad you found it.
Forum: General Motorcycle Discussion Forum   06-08-2016, 07:39 PM
Replies: 9
Views: 2,244
Posted By Nightrider1
That seems a little high to me for Bluetooth...

That seems a little high to me for Bluetooth wireless. You may be correct though.
Forum: General Motorcycle Discussion Forum   06-08-2016, 07:37 PM
Replies: 12
Views: 557
Posted By Nightrider1
Joe, that's around an average price for s nice...

Joe, that's around an average price for s nice 1100. If I had to do it again, I would At least start out with an 83 Aspencades. I'm just partial with that model, especially on the Aspy. They were the...
Forum: General Motorcycle Discussion Forum   06-08-2016, 07:28 PM
Replies: 11
Views: 830
Posted By Nightrider1
Sharp✅

Sharp✅
Forum: Goldwing Technical Forum   06-08-2016, 07:22 PM
Replies: 17
Views: 940
Posted By Nightrider1
It could've as simple as a carburetor problem. I...

It could've as simple as a carburetor problem. I had the Similar problem on my Goldwing and it had bad fuel and s dirty carb. Check your fuel filter for water. If rich and stinking, that also shouts...
Forum: Goldwing Technical Forum   06-08-2016, 08:22 AM
Replies: 18
Views: 939
Posted By Nightrider1
I'm getting the stock line from Harold. Thanks...

I'm getting the stock line from Harold. Thanks everyone.
Forum: Goldwing Technical Forum   06-07-2016, 07:37 PM
Replies: 18
Views: 939
Posted By Nightrider1
I went and checked. I don't have the male adaptor...

I went and checked. I don't have the male adaptor that goes into the stock right sidde shock. Gonna take it to napa tomorrow and see if I can make an adaptor that will work.
Forum: Goldwing Technical Forum   06-07-2016, 07:09 PM
Replies: 18
Views: 939
Posted By Nightrider1
I removed the left one and the lines. I see what...

I removed the left one and the lines. I see what you mean by the t connector. I'll put it on tomorrow. I put the stock spring on ithe left and the ride is 75% better. I'll order the seal kit. Thanks...
Forum: Goldwing Technical Forum   06-07-2016, 04:58 PM
Replies: 18
Views: 939
Posted By Nightrider1
Just my luck. They are chrome colored. Both 416s...

Just my luck. They are chrome colored. Both 416s need rebuilt. Both are leaking oil. Won't be anytime soon. This compressor won't work with the stock shocks. I'm grounded for awhile. Thanks for the...
Forum: Goldwing Technical Forum   06-07-2016, 02:03 PM
Replies: 18
Views: 939
Posted By Nightrider1
They are very dull, but may be from the road...

They are very dull, but may be from the road grime. I going to double check them this evening. I got pressure when I sealed the t connector. At a mi I mum air pressure up to 70 lbs air I hit a small...
Forum: Goldwing Technical Forum   06-07-2016, 10:53 AM
Replies: 18
Views: 939
Posted By Nightrider1
Thanks for the info.

Thanks for the info.
Forum: Goldwing Technical Forum   06-07-2016, 09:45 AM
Replies: 18
Views: 939
Posted By Nightrider1
They are Progressive 416's. What would be best to...

They are Progressive 416's. What would be best to do, go stock or these? Both 416's have bottomed out. Is there anything inside them that has to be changed like seals or something? How much oil...
Forum: Goldwing Technical Forum   06-07-2016, 09:34 AM
Replies: 18
Views: 939
Posted By Nightrider1
It is these....

It is these....
Forum: Goldwing Technical Forum   06-06-2016, 05:40 PM
Replies: 18
Views: 939
Posted By Nightrider1
Help. I got shock problems for sure now

Hey Everyone. My Hats off to Harold Augustine. God bless him and his!!!! I got my shocks in today. I got the rear lifted up And I found I've got a pair of air shocks on both sides of my 90SE!!! I'm...
Forum: Goldwing Technical Forum   06-04-2016, 03:25 PM
Replies: 4
Views: 275
Posted By Nightrider1
Thanks!!!!!!

Thanks!!!!!!
Forum: Goldwing Technical Forum   06-03-2016, 12:51 PM
Replies: 14
Views: 928
Posted By Nightrider1
Make it simple. Mark your timing gears well and...

Make it simple. Mark your timing gears well and Lock down your timing pullys. I used vise grips on mine. Don't tighten the grips too tight but only enough to hold them in place. If either pulleys...
Forum: Goldwing Technical Forum   06-03-2016, 12:44 PM
Replies: 4
Views: 275
Posted By Nightrider1
Front tire question

On my 1500, it had some wear on the front left side of the tire when I bought it. Then it got bad. I figured it must had been caused by my sidecar. I had the wheel bearings changed along with all...
Forum: General Motorcycle Discussion Forum   06-03-2016, 12:38 PM
Replies: 13
Views: 842
Posted By Nightrider1
I have always run Dunlop. I put Shinko...

I have always run Dunlop. I put Shinko Tourmasters on last because I could not afford any dunlops. I'm really suprised at the LESS WEAR I've not had. I have noticed a little rougher ride with these....
Forum: Goldwing Technical Forum   06-03-2016, 12:15 PM
Replies: 6
Views: 269
Posted By Nightrider1
Also remember the wires will get hot even if they...

Also remember the wires will get hot even if they are ok. Don't painic. It's normal.
Forum: Goldwing Technical Forum   06-03-2016, 12:12 PM
Replies: 6
Views: 269
Posted By Nightrider1
That happened to me on my 80. I had the stator...

That happened to me on my 80. I had the stator checked. It was goof. About a year earlier I had removed the wiring harness and soldered the connectors. They were ok. My problem was a dying cheap...
Forum: Goldwing Technical Forum   06-03-2016, 11:52 AM
Replies: 7
Views: 308
Posted By Nightrider1
I got low on gas on my 83in Birmingham. I topped...

I got low on gas on my 83in Birmingham. I topped the tank off and it run like crap back to Gadsden. Had to clean the carbs. On my 1500 i got gas at one place twice at the same station and it run like...
Forum: Goldwing Technical Forum   06-03-2016, 11:37 AM
Replies: 10
Views: 1,381
Posted By Nightrider1
When I first started restoring my 80's I'd always...

When I first started restoring my 80's I'd always over generalized on any repair, making it tougher than usual. After a lot of screwing up I learned really quick. If it's simple. Dont make it more...
Forum: Goldwing Technical Forum   06-03-2016, 11:33 AM
Replies: 18
Views: 3,017
Posted By Nightrider1
I got to agree with AZ. The stator connectors are...

I got to agree with AZ. The stator connectors are on the left side. Check from the battery connection to the wiring harness. A burning smell will give you a hot wire to the touch. Also look and check...
Forum: Goldwing Technical Forum   06-03-2016, 11:25 AM
Replies: 7
Views: 987
Posted By Nightrider1
I went to see the bottle. It's made by Valvoline....

I went to see the bottle. It's made by Valvoline. Dot 3 and 4
Showing results 1 to 25 of 500

 
Forum Jump
 
For the best viewing experience please update your browser to Google Chrome