Steve Saunders Goldwing Forums - Search Results

Advanced Search
Showing results 1 to 25 of 69
Search took 0.01 seconds.
Search: Posts Made By: captng1
Forum: For Sale/Wanted Forum   01-06-2018, 02:19 PM
Replies: 2
Views: 211
Posted By captng1
Thanks Ken, Wasn't sure if these parts were...

Thanks Ken,
Wasn't sure if these parts were still available through Honda. I have already called them. They are looking into it...
Forum: For Sale/Wanted Forum   01-06-2018, 01:38 PM
Replies: 2
Views: 211
Posted By captng1
Right Front Brake Slider Sleave/Bushing

Looking for a right front brake slider sleve/bushing and the two end rubber boots for a 1984 GL 1200. Anyone know where I might find them?
Thanks
Forum: Goldwing Technical Forum   01-06-2018, 10:32 AM
Replies: 44
Views: 2,619
Posted By captng1
Thanks Dodge!

Thanks Dodge!
Forum: Goldwing Technical Forum   01-06-2018, 10:31 AM
Replies: 44
Views: 2,619
Posted By captng1
Thanks Redwing!

Thanks Redwing!
Forum: Goldwing Technical Forum   01-03-2018, 05:39 PM
Replies: 44
Views: 2,619
Posted By captng1
Hi Dodge, I have had the master cylinder off a...

Hi Dodge,
I have had the master cylinder off a few times now. I have not rebuilt it, just ran a wire through the relief hole and put it back on. Was not that difficult. I have not changed the...
Forum: Goldwing Technical Forum   01-03-2018, 05:33 PM
Replies: 44
Views: 2,619
Posted By captng1
Thanks Jimh352 :)

Thanks Jimh352 :)
Forum: Goldwing Technical Forum   12-28-2017, 10:19 AM
Replies: 44
Views: 2,619
Posted By captng1
Hi Redwing, Once the pedal is pushed, the...

Hi Redwing,
Once the pedal is pushed, the brakes drag so heavily that I can barely roll the bike while in neutral! I have to crack the line to release the pressure. I'm going to try and get a used...
Forum: Goldwing Technical Forum   12-27-2017, 04:46 PM
Replies: 44
Views: 2,619
Posted By captng1
Thanks for your input 81MarineE5

Thanks for your input 81MarineE5
Forum: Goldwing Technical Forum   12-27-2017, 04:44 PM
Replies: 44
Views: 2,619
Posted By captng1
Hi Redwing, See my reply to Dave... Thanks

Hi Redwing,
See my reply to Dave...
Thanks
Forum: Goldwing Technical Forum   12-27-2017, 04:42 PM
Replies: 44
Views: 2,619
Posted By captng1
Yes Dave, it was a very tiny hole that I could...

Yes Dave, it was a very tiny hole that I could only fit a single strand of very fine wire into...
Nothing in the pedal or linkage has changed. The brake started dragging after sitting for an...
Forum: Goldwing Technical Forum   12-27-2017, 01:55 PM
Replies: 44
Views: 2,619
Posted By captng1
Thanks Redwing, See my reply to Dave below...

Thanks Redwing,
See my reply to Dave below...
Forum: Goldwing Technical Forum   12-27-2017, 01:42 PM
Replies: 44
Views: 2,619
Posted By captng1
Thanks Dave, Already replaced the rubber hose...

Thanks Dave,
Already replaced the rubber hose and rebuilt the caliper with new seals and pistons. The pedal returns all the way. Yes, the front brake drags as well. Although I took the master...
Forum: Goldwing Technical Forum   12-26-2017, 10:52 AM
Replies: 44
Views: 2,619
Posted By captng1
Yes PaPete, I did all of that. Thanks

Yes PaPete,
I did all of that.
Thanks
Forum: Goldwing Technical Forum   12-25-2017, 09:08 AM
Replies: 44
Views: 2,619
Posted By captng1
Yes Ken, I can bleed the brakes, but I believe...

Yes Ken,
I can bleed the brakes, but I believe the small relief port in the master cylinder has a problem although I have run a small piece of wire through it? Brakes are still dragging, and I'm out...
Forum: Goldwing Technical Forum   12-24-2017, 04:30 PM
Replies: 44
Views: 2,619
Posted By captng1
Thanks Dennis, I'm guessing there are no After...

Thanks Dennis,
I'm guessing there are no After Market shops that sell new ones? I hate to buy a used one off ebay and have the same problem...
Forum: Goldwing Technical Forum   12-24-2017, 04:28 PM
Replies: 44
Views: 2,619
Posted By captng1
Hi Ken, Not sure how you get to that...

Hi Ken,
Not sure how you get to that conclusion? When bleeding the brakes, you are pumping fluid down the main tube and releasing it out the caliper. The return hole is not in use when sending fluid...
Forum: Goldwing Technical Forum   12-24-2017, 04:22 PM
Replies: 44
Views: 2,619
Posted By captng1
Hi Pure Texas, Yes, caliper was cleaned inside...

Hi Pure Texas,
Yes, caliper was cleaned inside and piston installed with fresh brake fluid. Thanks..
Forum: Goldwing Technical Forum   12-24-2017, 01:33 PM
Replies: 44
Views: 2,619
Posted By captng1
Thanks. Not sure rebuilding will fix it if the...

Thanks. Not sure rebuilding will fix it if the internal hole has an obstruction in it? The seals and all seem fine as it does build up pressure when pumped. Just doesn't release the pressure....
Forum: Goldwing Technical Forum   12-24-2017, 11:47 AM
Replies: 44
Views: 2,619
Posted By captng1
It only has one rear caliper, but if you mean on...

It only has one rear caliper, but if you mean on which side of the rotor, I couldn't say? Pin is greased and free. It seems now it is also making the right front bake drag as well, which tells me it...
Forum: Goldwing Technical Forum   12-24-2017, 11:06 AM
Replies: 44
Views: 2,619
Posted By captng1
Dragging Brake Update

Hi Guys,
A Merry Christmas To All! So my rear brake has been dragging. I removed and rebuilt the rear caliper with new pistons, seals, and pads, cleaned and greased the guide bolt and sleeve,...
Forum: For Sale/Wanted Forum   01-18-2017, 12:59 PM
Replies: 4
Views: 305
Posted By captng1
Anyone have a 1984 Goldwing Side Cover Emblem?

Does anyone have a Goldwing side cover emblem for a 1984 GL1200. It's the one with the large W in the middle. I'm thinking a used one will match the rest of the bike better than a shiny new one......
Forum: For Sale/Wanted Forum   01-16-2017, 08:40 AM
Replies: 4
Views: 410
Posted By captng1
Thanks Dennis, I appreciate your help, but...

Thanks Dennis,
I appreciate your help, but gonna have to pass...
All The Best,
Forum: For Sale/Wanted Forum   01-15-2017, 02:02 PM
Replies: 25
Views: 998
Posted By captng1
Found it. Thanks Cihilb...

Found it. Thanks Cihilb...
Forum: For Sale/Wanted Forum   01-15-2017, 01:12 PM
Replies: 4
Views: 410
Posted By captng1
Used battery Cover 1984 GL1200

Looking for a used battery cover for a 1984 GL1200 preferably in the Wineberry color. Let me know if you have one in good shape...
Thanks,
Gary
Forum: Goldwing Technical Forum   12-28-2016, 09:02 AM
Replies: 15
Views: 789
Posted By captng1
Hi Tom, The pistons had some signs of pitting...

Hi Tom,
The pistons had some signs of pitting in them. I didn't like them so just decided to change everything! Pads too...
Showing results 1 to 25 of 69

 
Forum Jump
 
For the best viewing experience please update your browser to Google Chrome