Steve Saunders Goldwing Forums - Search Results

Advanced Search
Showing results 1 to 11 of 11
Search took 0.02 seconds.
Search: Posts Made By: WALTSTAR
Forum: Goldwing Technical Forum   09-07-2019, 06:19 AM
Replies: 30
Views: 1,586
Posted By WALTSTAR
Ive owned the bike since 2001. The problem...

Ive owned the bike since 2001. The problem appeared when I pulled it out this spring and caused me to do a wire and plug replacement as well as temp sensor and tightening of all connections.
Forum: Goldwing Technical Forum   09-06-2019, 09:43 AM
Replies: 30
Views: 1,586
Posted By WALTSTAR
OR SO I THOUGHT.... Took her out and the idle...

OR SO I THOUGHT....
Took her out and the idle still hunts, although only 500 RPM top to bottom now (rather than the 2000 RPM as before). I get the smell of UN-burnt hydrocarbons as well and the bike...
Forum: Goldwing Technical Forum   08-10-2019, 03:52 PM
Replies: 30
Views: 1,586
Posted By WALTSTAR
Ok, so I have installed the sensor and waited a...

Ok, so I have installed the sensor and waited a week before starting the wing.....Voila! problem solved. Thank you for the guidance, Guru's! I did the 6 and then 4 degree trigger wheel about 17 years...
Forum: Goldwing Technical Forum   04-23-2019, 07:42 AM
Replies: 4
Views: 253
Posted By WALTSTAR
Thank you for the tip. After two forums and over...

Thank you for the tip. After two forums and over 100 views, you were the only one to respond. How about the balancer connections?
Thanks again
Forum: Goldwing Technical Forum   04-21-2019, 08:46 PM
Replies: 4
Views: 253
Posted By WALTSTAR
Diagnostic connections

On the possibility of tearing into the carbs, I need to know where and how to hook up a external tach and my mercury balancers...
Any info? Thanks.
Forum: Goldwing Technical Forum   04-17-2019, 06:33 AM
Replies: 30
Views: 1,586
Posted By WALTSTAR
Good advice. Ive heard of that and since all...

Good advice. Ive heard of that and since all other functions are spot on, I will look into the hose. Where exactly is it? Can I get to it just be removing the side fairing?
Forum: Goldwing Technical Forum   04-13-2019, 06:54 PM
Replies: 30
Views: 1,586
Posted By WALTSTAR
When I bought the bike 20 years ago, I put a 6...

When I bought the bike 20 years ago, I put a 6 degree in it and then pulled it to replace it with a 4 degree. It ran fine all this time until recently.
Forum: Goldwing Technical Forum   04-12-2019, 06:33 PM
Replies: 30
Views: 1,586
Posted By WALTSTAR
Yup, first thing was tighten and dab gasket...

Yup, first thing was tighten and dab gasket shellac on the screws. I have mercury balancers, but want to
1) seafoam the carbs to try and clean the off idle squirters
2) check the pump diaphragm if...
Forum: Goldwing Technical Forum   04-12-2019, 12:27 PM
Replies: 30
Views: 1,586
Posted By WALTSTAR
Thanking you, I will start to investigate the...

Thanking you, I will start to investigate the cause with your documentation. Walt.
Forum: Goldwing Technical Forum   04-11-2019, 02:46 PM
Replies: 30
Views: 1,586
Posted By WALTSTAR
Hunting idle, dead spot off idle

I went through the '88 GL1500 and put in new ignition wires, E3 plugs, tightened all the carb connections, found no cracked hoses, cleaned the coils, rebuilt the cooling system after ...
Forum: Goldwing Technical Forum   04-19-2015, 07:42 AM
Replies: 2
Views: 235
Posted By WALTSTAR
88 cb and radio interface

i have a 88 gl 1500 and it has performed flawlessly for years. however, i havent had her out of the garage for a while and when i took her out two days ago (not much time to get out in the northeast...
Showing results 1 to 11 of 11

 
Forum Jump
 
For the best viewing experience please update your browser to Google Chrome