I bought this bike in Sept of 2011..it had been sitting for a while..but I rebuilt the motor, changed just about every component and part I can source..and look forward to riding this for many years to come
1985 Honda Interstate (Burgandy)
Changed from Dunlop to Perilli, replaced the wheel bearings and seals..using bearings from All Balls Racing.
Rebuild motor, Intake and Final drive, finished that Jan 4th of 2013. also rebuilt all the master cylinders (Clutch, front and rear brakes) and re built all three calipers including putting new pistons in them, and added speed bleeders to the brakes and clutch.
A wrap around windshield, Chrome front turn signal covers, LED side marker lights on the fairing, replaced the reflectors on the saddle bags and the rear center with lights, did the trunk light conversion using amber lenses, and also did the bag turn light conversion. I took and put some wire cables and attached them to the bag lids so they won't blow off , and added cold cathode lights to the inside of the saddle bags and trunk. also added a LED voltage gauge
Added progressive springs to the front forks, rebuild the anti dive system and replaced the rubber bushings in the rear shocks and replaced the speedo unit with a new one. also replaced the swing arm bearings and steering head bearings and seals with All Balls racing bearings.
Airhawk 2 seat
Wheel and Tire
I have a GPS, JVC Stereo, iPod, XM Radio, J&M Communications, Cruise control (not a throttle lock) and just added a Go Pro 2 set up