Steve Saunders Goldwing Forums banner
Status
Not open for further replies.
1 - 5 of 5 Posts

·
Premium Member
Joined
·
487 Posts
Discussion Starter · #1 ·
imported post

hi just purchased a carbtune [manometer] for balancing the throttles etc.

does anyone know if it can also be used to balance the 4 pilot screw adjustments?

thx gumby
 

·
Registered
Joined
·
10,509 Posts
imported post

Might be worth a try but mostly you set them by using a good tachometer, not the one on the bike.
 

·
Premium Member
Joined
·
487 Posts
Discussion Starter · #3 ·
imported post

hi and thx for the reply. where would i install the external tach. my bike tach is mechanical so
no electrics to place the 3rd wire.. red to 12v black to ground. the 3rd wire where
would it go??

thx gumby
 

·
Registered
Joined
·
10,509 Posts
imported post

I think you would have to hook it up to the pulse generators or the coils.
 

·
Administrator
Joined
·
27,770 Posts
imported post

You would connect the tach to either coil, the blue or the yellow wire. If it has a 2 cylinder mode it would read right, I think. If you have to use 4 cyl mode it would read 1/2 actual RPM.
 
1 - 5 of 5 Posts
Status
Not open for further replies.
Top