[bumblebee]

imported post

Hi Guys



I have the EEE signal and I am working through the connections to clean them up, what I need to know is if the EEE is showing is there any air in the suspension system? If so is there a way of checking the pressure directly? Is there a way to change the pressure in the system by external pump or compressor?

 

[blackknytecnc]

imported post

Mine does that too every once in a while, but it usually resets after turning the key off and on. If yours won't reset I'd go after the nasty connectors. I think I've seen on a couple of these threads that there is a port on one of the forks that you can check the pressure manually, but I have no clue where it is. Hopefully someone more knowlegable will be along soon.

 

[neoracer]

imported post

on the ltd u should have a fill port located on the left front fork and in the rear at the air distribution block under the right side cover,this allows checking or filling w/o use of the air compressor

 

[wingsam41]

imported post

neoracer wrote:

on the ltd u should have a fill port located on the left front fork and in the rear at the air distribution block under the right side cover,this allows checking or filling w/o use of the air compressor

Sound advice-here's a pic of the front valve...the red straw from a carb cleaner can is touching it...

 

[bumblebee]

imported post

thanks for your help guys very appreciated