Steve Saunders Goldwing Forums banner
Status
Not open for further replies.
1 - 2 of 2 Posts

·
Premium Member
2000 GL1500SE
Joined
·
3,360 Posts
imported post

I would take the calipers apart and clean the pistons and bore really good. Also clean out the recessed area that the seal goes in to make sure the seal can go all the way down in it. These often get clogged with dirt and crud. Make sure the slider pins are clean and lubed so the caliper can float on the mount. This will likely clear up your sticking brake problem.
 

·
Premium Member
2000 GL1500SE
Joined
·
3,360 Posts
imported post

Good point Redwing. I forgot about that one.
 
1 - 2 of 2 Posts
Status
Not open for further replies.
Top