Steve Saunders Goldwing Forums banner
Status
Not open for further replies.
1 - 4 of 4 Posts

·
Premium Member
Joined
·
35 Posts
Discussion Starter · #1 ·
Hey Gang,
Has anyone had to reattach the valve cover emblem? What does the factory use to attach a plastic emblem to a hot metal valve cover? For whatever reason, the 1990 bike I am restoring has the emblems off of the valve covers. Thanks
Jeff
 

·
Premium Member
Joined
·
12,063 Posts
I used 3-M brand double sided tape used for vehicle
trim been on the bike for 4 months no problems yet.
 

·
Premium Member
Joined
·
815 Posts
I purchased a new set of emblems, they have tape in place.
I would check if the 3M tape is heat resistant as the cover gets very hot.
You dont want them falling off as they are quite expensive items.
 

·
The Irish Crew
Joined
·
3,932 Posts
The emblems come with very strong rubbery tape. It's very hard to remove from the rocker covers when the emblems are pulled off.
 
1 - 4 of 4 Posts
Status
Not open for further replies.
Top