[oldflyboy59]

imported post

I am looking for a wheel chock that I can put inside my trailer that will work well with my 1800. Does anybody have a favorite that they have had good luck with ?

 

[satan]

imported post

I've not had the opportunity to work this with an 1800, but they're very handy on the 1500.

The cross-bar bolts nicely to a trailer's floor.


http://www.harborfreight.com/motorcycle-stand-wheel-chock-97841.html

 

[SETHAN12]

imported post

Condor wheel chock

A bit pricey, but it cradles the bike and holds it up while you tie it down.

 

[satan]

imported post

Yep -- I believe the Condor is hwere HF may have "borrowed" some design from...

'bout the only major difference is that the "back" wheel cup has solid sides where the Condor has 2-fingers per side. And the frame is essentially angle-stock with cross bracing and not c'channel (and about $110 )

 

[oldflyboy59]

imported post

Thanks

 

[skinose]

imported post

I have a Harbor Freight chock that cost me $39.00 and is now $29.00 when on sale.

You drive the bike on it and it has a rear bar that rises and locks the front tire in and about 1 inch off the floor. Great value. I also purchased 3" aluminum angle that is abou t3/8" thick and made side supports as a chock for the rear tire. Rear has support now on both sides and can not slide side-to-side.