Steve Saunders Goldwing Forums banner
Status
Not open for further replies.
1 - 1 of 1 Posts

·
Premium Member
Joined
·
2,163 Posts
Refer to your last picture.
The aluminum plug or "puck is the round disc on the left side. This puck needs to be removed to access and clean the idle circuit(s).
You've already removed the holding fixture/jets and rubber bung plug.
Although it looks like a screw driver slot, the jet on the left does not screw in to the body. If you invert the carb body, and remove the slide and needle, you can see the bottom of the jets. Gently push them out of the carb,
The jet in middle is screwed in. Be very careful to use the proper size and style of screw driver, or you may fold or knurl the top of the jet.
A little compressed air goes a long way toward removing a stubborn jet.
A good trick is to place the body in a plastic bag to catch any part that might want to leave the rebuilding station, then blow as many out as possible.
 
1 - 1 of 1 Posts
Status
Not open for further replies.
Top