Steve Saunders Goldwing Forums banner

Status
Not open for further replies.
1 - 3 of 3 Posts

·
Premium Member
Joined
·
29 Posts
Discussion Starter · #1 ·
imported post

Used a sheet rock screw to pull my slow speed jets out, they were very plugged to say the least.. wondering where I can get new ones, as bike bandit doesn't list them in the oem parts section. So i was wonderign if any one knew what jet it was.. they are the push in type
Thanks
Rob
 

·
Administrator
Joined
·
26,992 Posts
imported post

You cannot get new ones for the 80-81s. They were only sold with the carb body. If you can find a tap in 6mm.75(I think) you can get 82-83 jets and thread them in. If you didn't do anything other than pull them out with a screw you should be able to clean and reuse them.
 

·
Premium Member
Joined
·
1,902 Posts
imported post

The NAPA carb cleaner with a can and basket will clean the jets just fine. Run the smallest strand of copper wire from electrical wire through the holes. Make sure light comes through.
 
1 - 3 of 3 Posts
Status
Not open for further replies.
Top