Steve Saunders Goldwing Forums banner
Status
Not open for further replies.

1981 GL1100 Standard

4K views 19 replies 12 participants last post by  col_freecycle 
imported post

A little trick I use to check a cylinder that isn't firing is this, as the bike is running I remove the sync screw from the manifold of the cylinder in question and shoot WD-40 through it. If the plug has spark then it usually starts running when the WD-40 is sprayed into the screw hole.

You may try this too to get it started long enough for the fuel pump to refill the carbs.
 
Status
Not open for further replies.
You have insufficient privileges to reply here.
Top