Steve Saunders Goldwing Forums banner
Status
Not open for further replies.
1 - 3 of 3 Posts

·
Premium Member
Joined
·
86 Posts
Discussion Starter · #1 ·
In the process of rebuilding a friend of mine carb.Going with 158/60 jets i have seen both 7.5 and 8 on the float height also what the recommended setting for the air screws?
 

·
It aint rocket science
Joined
·
3,966 Posts
8mm for the 88, 89-92 were 7.5. With the original 50 jet initial setting was 3 1/8 out with the 55 for the campaign it was 2 1/8. I would put them in the 1 3/4....2 out for the 60. 58 jet would also have been a good choice.

Grind the tabs off for full adjustment with your slotted screwdriver for final tuning.:) With the 55 jets in mine I am about 2 3/8 out.

http://www.goldwingfacts.com/forums...lot-screw-limiter-cap-work-around-1500-a.html
 
1 - 3 of 3 Posts
Status
Not open for further replies.
Top