Steve Saunders Goldwing Forums banner

Status
Not open for further replies.
1 - 4 of 4 Posts

·
Premium Member
Joined
·
151 Posts
Discussion Starter #1
imported post

I have two projects left before the ol' girl starts going back together. Kinda near each other so I'll start with the shift shaft seal. It appears if I remove the left header the seal replacement may be easier...any pointers? Second is the little metal piece about 8" long that is trapped between the header and the kickstand. Any sneaky ways to remove this part, paint is peeled, part is heavily rusted and needs attention, short of dropping the left header? Are there gaskets between the header and cylinder head that I should replace? Ahhh make that three projects, replace fork oil. Tia, Rick.
 

·
Premium Member
Joined
·
628 Posts
imported post

You should be able to replace the seal with the header fitted. The short painted piece is another matter and very difficult to get out without bending it and damaging the paint. I think you will need to drop the header for that.
 

·
Still Learning
Joined
·
13,270 Posts
imported post

And yes there are exhaust manifold donuts that will need replacing.
 

·
Still Learning
Joined
·
13,270 Posts
1 - 4 of 4 Posts
Status
Not open for further replies.
Top