82 GL1100 Aspencade Starter Refresh

34754 Views 91 Replies 47 Participants Last post by CrystalPistol, Dec 22, 2012

Mr Magic Fingers

Discussion Starter · Jul 1, 2009

imported post

Hi Everyone,

I just completed a “refresh” of a really sluggish starter on my 82 Aspencade. It was sluggish at times (more times then not) and would sound like the battery was going dead. It would draw so much current that I lost my radio presets a few times. My battery is in good shape and seems to test fine on a stress test.

I had a golden opportunity to do this refresh as I was doing other work to the bike and the exhaust was off. I was staring right at it. It’s done and WOW! What a difference!! Not a hard job, no money involved for me, just my time. Here’s what I did.

First thing to note is that the bike was on the center stand. Some people say yes to this and others say no. My recommendation would be to have the bike on the center stand. This can be done with the exhaust system on but I am glad mine was off. I don’t think there would have been an issue with it on, just a bit more wrangling to get your hands in there.

VERY IMPORTANT – Remove the battery from your bike or at the very least disconnect the positive (RED) lead from the battery and TAPE it back so it can’t spring back to the battery post. No one wants a lead acid battery exploding in their face from a dead short! Safety comes first.

Here we go…

Remove the power cable that goes to the starter. VERY IMPORTANT - Make sure you use a thin end wrench to back up the lug when removing the nut from the positive lead. Ifthat bolt starts to turn it may sever the conection internaly and the starter may have to be replaced.

Remove the two bolts that mount the starter to the engine. Pull back the freed starter while wiggling it. When it is free from the engine, tilt it out and up until the starter shaft clears the engine and remove the starter. You may have to push down on the gear shift to gain a bit more room.

See less See more

Save

1 - 2 of 92 Posts

GSMacLean

· #51 · Jul 23, 2009

imported post

Mr Magic Fingers wrote:

Just about everything I do to the bike I document with pictures. I have 100’s (I do photography too) of detail pictures. I like creating the “how to” articles but there are way more experienced people out there. Who am I to say how something is done?

I do the same thing, which is why I have all the "How To" articles on my site. I follow the service manual, put in some tips from others that I've read, and add some common sense. Don't worry about it - if you get something wrong, or need something added, people will let you know, and then you can add that in!

Save

GSMacLean

· #82 · Jan 7, 2012

imported post

mrclean wrote:

2 when I went to install the new starter.....the new gear that rests on the chain was just a tad too big and no mater what I did the new starter would not fit.....no way.

3 solution....use the old gear from the origional starter and the new starter slid right into place on the first attempt.

That's not the first time I've heard of this happening to someone, and each time they arrived at the same solution as you.

Save

1 - 2 of 92 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

82 GL1100 Aspencade Starter Refresh

Mr Magic Fingers

Attachments

GSMacLean

GSMacLean

Top Contributors this Month