Steve Saunders Goldwing Forums banner
Status
Not open for further replies.
1 - 2 of 2 Posts

· Still Learning
Joined
·
13,275 Posts
Welcome to the forum DatsunChris

Brake light- There are 2 wires that plug in the brake switch under the front master cylinder.
A green/white , and a green/yellow.

Front turn signals need, orange is left turn, light blue is right turn, green is ground on both lights.

With LED turn lights you will need a LED electronic flasher instead of the thermal flasher that was used then or you will get too fast a flash rate to be legal. I have used the Grote 44890 flasher. There are other flashers you can use. Otherwise you would have to get load resistors for each LED light to add a load to give the same draw on the thermal flasher but those load resistors build heat and get real hot and add draw on the charging circuit.

I also saw your pics of the bike in the new members section, looks like the fairing weight is still on the front behind the headlight. That needs to be removed and a headlight bucket used instead to hold the headlight and the wire connections inside of the bucket.
 

· Still Learning
Joined
·
13,275 Posts
bobalou
Happy New Year!
Are you in TX now????
 
1 - 2 of 2 Posts
Status
Not open for further replies.
Top