Steve Saunders Goldwing Forums banner
Status
Not open for further replies.
1 - 2 of 2 Posts

· Premium Member
Joined
·
8,099 Posts
No telling what the po did to it so you are going to have to trace wires. Get the wire diagram from the tech area I used to have them for all the early years. A good sharp test light probe. If the colors match the schematic at the back look for the match in the headlight bucket, follow them from that poiint to the turn sigs. Use the probe to verify the wire by function of the light. Check for an electronic flasher as LED do not have the resistance to make a standard flasher flash. Post any further q's or PM me.
 

· Premium Member
Joined
·
8,099 Posts
bobalou
Happy New Year!
Are you in TX now????
I wish!! But it had four inchs snow in Texarkana! Glad to be in Washington for the time being. No work here and getting hungry. shutting off the power to conserve. Got certfied as a pilot car Escort. and looking into renting a truck for CDL. Alot of work in the trucking arena it looks like. Need CDL to be a Steerman/Tillerman. Doing clutch repair for now. and attempting to sell my Mustang. Running out of things to sell. Got some parts back from the chromer, they didn't do a real good job but good enough for free. The parts look 1000 times better. Will get a pic or two up soon. Happy New Year to you as well. I don't know how or when I need to be back in Texas yet and if I go on my bike this time I am hoping to take a route that runs into a few from the forum.
 
1 - 2 of 2 Posts
Status
Not open for further replies.
Top