Steve Saunders Goldwing Forums banner

Status
Not open for further replies.
1 - 4 of 4 Posts

·
Premium Member
Joined
·
8 Posts
Discussion Starter #1
imported post

Anybody know the diameter of the end of the crankshaft on an '84 Aspencade?Theshaft diameter, not the bearing that it rides in, is what I need. And are both ends the same dimension? I have an incomplete manual here....any info on this would be appreciated! Thank you! Loren
 

·
Premium Member
Joined
·
4,910 Posts
imported post

Sorry, I can't help you there, but I'm very curious why you need to know that? Wassup? You're planning something really cool, aren't you...:baffled:

The last time I messed with camshaft bearings was on an old Ariel Square Four for a friend. He needed the end bearing ground undersize, and a new insert for it to press into the head journal...;)
 

·
Premium Member
Joined
·
3,200 Posts
imported post

Checked Clymer, Haynes, and the Honda manual and could not find camshaft diameters...only diameters for the bearing journals. Someone will come along with the info you need though.

Good luck!
 

·
Premium Member
Joined
·
8 Posts
Discussion Starter #4
imported post

SORRY GUYS! What I meant to state was CRANK shaft, not camshaft. And, yes, I am doing something weird....gonna attempt to pull the crank and put an electric motor in its place. This Aspencade came to me with no saddle, no carbs, dismantled clutch cable, and I am creating an electric reverse trike. Any info on the CRANKshaft diameter? Thanks again! Loren
 
1 - 4 of 4 Posts
Status
Not open for further replies.
Top