Steve Saunders Goldwing Forums banner

86-87 GL1200 wheel hub needed

510 Views 6 Replies 4 Participants Last post by  WNGNUT
imported post

I am putting a sidecar on my wing and I have a car tire conversion for it. Only trouble is it needs to have the bigger hub found on the 86 or 87 GL1200 and mine is a 84. If anyone has a extra please let me know.

Thanks Wesley

[email protected]
Status
Not open for further replies.
1 - 7 of 7 Posts
imported post

are you needing the drive flange for the 86? if so I think I know where one is, and he needs one for an 84 :clapper:JBZ might need it.
imported post

Thanks Ray but I think I got it covered. This is what I came up with. The 84 and 85 wheels take the small hub and 86 and 87 take the large hub. Both are 6 pins. The wheels are also differant so for a 86 or 87 wheel you need a 86 or 87 drive hub to go with it and the 84 and 85 wheel takes the 84 and 85 drive hub.. The depth of the hubs where it slides over the bearing in the wheel is also differant Dont take this for 100 per cent but I am pretty sure that is how it is working. 86-87 drive hub 2.550 inside diameter by .650 deep 84 85 hub 2.350 diameter by.950 deep JB
imported post

That sounds about right JB. Do you have an extra?

Thanks, Wes
imported post

Wish I did Wes but that one I took off was totally hammered. you might consider adapting the 1500 final drive and wheel on it. Some members have done it. JB
imported post

My mechanic replaced my '87 1200aspencade drive flange with one from an '88 1500. It bolted right up. Good luck!
imported post

Thanks, I'll try that:eek:)
1 - 7 of 7 Posts
Status
Not open for further replies.
Top