Steve Saunders Goldwing Forums banner
1 - 1 of 1 Posts

·
Administrator
Piaggio MP3, was 02 GL1800
Joined
·
61,996 Posts
With float bowl removed and carb upside down, measured the heel of the float to the the carb flange, adjusted by bending the brass tab which the needle hangs from, I set them to spec, I don't remember the actual number but they were all a couple millimeters high and all by the same amount. It's very possible that something else has been changed but I will have to pull the carbs back out to check.
someone correct me if I am wrong, but I thought the carbs needs to be vertical and the float just barely touching the needle with the specified measurement?
 
1 - 1 of 1 Posts
Top