[Fastymz]

I've used these in the hotrods or older cars I've had. Have any of you added them to your goldwings? If so where did you mount them?

I like this set up its prewired has a relay and very easy to intall.
http://www.summitracing.com/parts/prf-70113/overview/

 

[Fastymz]

I have used these too mainly for the price, they require you to run the wiring yourself. But they cost a lot less.

http://www.summitracing.com/parts/hla-h84960091/overview/

 

[OldSchool_IsCool]

I DIY'd it for under 10 bux. Mounted it on top of the air filter of my 1100 where it was sure to not chafe and touch ground.

 

[newday777]

Use the shorter height fuse blocks rather than the first link for clearance.
Definitely cheaper to wire it yourself. 30A Relay is $5.99 locally or less on line. and a 30A fuse holder is @$5 then it's just wire and connectors, solder and heat shrink wrap.
That is a good spot on the air cleaner if no compressor in the way, or you can put it on a flat ABS sheet that sticks out the side to put under the battery holder clamp rubber under the side cover.

 

[newday777]

Or anywhere there is easy access to the fuses, trunk, fairing pocket

Adding safe power by Rudy
http://goldwingtech.info/auxwiring/auxpwrwiring.html
wiring in a relay
http://www.r1200gs.info/howto/relay.html

 

[TennX]

Im not rich, but I am lazy, I bought the Electrical Connection block, only negative was no ground block...but I got it figured out. good luck

 

[erwjww]

I bought similar to this. One in trunk and one in left pocket:

http://www.ebay.com/itm/ATC-ATO-6-W...Parts_Accessories&hash=item35c491ca6b&vxp=mtr


For ground block I went to Radio Shack and bought a couple 6 position (iirc) ground blocks.

Hooked up the "Rudy" way.
http://goldwingtech.info/auxwiring/auxpwrwiring.html