Steve Saunders Goldwing Forums banner
Status
Not open for further replies.
1 - 2 of 2 Posts

·
The Irish Crew
Joined
·
3,932 Posts
imported post

The extensions on my GL1100 are like that. Two half moon spacers take up the gap between the old tailpipe and the new extenstion, but there is also a slot in the extensions with a bolt for tightening the extensions over the spacers.
 

·
The Irish Crew
Joined
·
3,932 Posts
imported post

jsmith24 wrote:
FitzAl wrote:
The extensions on my GL1100 are like that. Two half moon spacers take up the gap between the old tailpipe and the new extenstion, but there is also a slot in the extensions with a bolt for tightening the extensions over the spacers.

Any chance you have a diagram or pic of these spacers, so I can fabricate my own?

Jack
I'll try and loosen the pinch bolt and slide the extension away next week Jack. If the bolts comes out without breaking from rust I'll do a template of the spacers for you. Please note that my extensions are straight out with a slight turndown, they don't taper like yours.
 
1 - 2 of 2 Posts
Status
Not open for further replies.
Top