Steve Saunders Goldwing Forums banner

Status
Not open for further replies.
1 - 3 of 3 Posts

·
Premium Member
Joined
·
106 Posts
Discussion Starter #1
imported post

I have an 85 limited. the pressure displays for the front and back pressure will regularly start showing EEE on both displays. Most of the time I will get one autolevel sequence out of it but if I request a second level setting, or if I try and do a manual pressure increase either it will error out or the manual pressure switch will not start the pump.

Anybody have any ideas what might be wrong, need cleaned, need replaced???

thanks
bob
 

·
Premium Member
Joined
·
720 Posts
imported post

I know that the displays are the normal problem here. The circuit board inside rots from rain etc. The silly part of this setup (as I understand it) is that some of the commands from the hbar switchesinterface through the display.
 
1 - 3 of 3 Posts
Status
Not open for further replies.
Top