Steve Saunders Goldwing Forums banner
Status
Not open for further replies.
1 - 1 of 1 Posts

·
Premium Member
Joined
·
12,956 Posts
imported post

Not John here but .... There should be a cotter pin and a flat washer on the end of the shaft the pedal pivots on . You might start with a squirt of PB Blaster on the pedal/pivot shaft . Let that soak a bit and begin to work the pedal up and down . It should loosen up and let you slide it off the shaft. Then proceed with the cleaning and lube . Some folks go as far as to install a zerk ( grease) fitting in the pedal while its off .
 
1 - 1 of 1 Posts
Status
Not open for further replies.
Top