Joined
·
3,816 Posts
imported post
Hardest part of the rebuild is getting the caliper off the bike, and the piston out of the the bore. Sometimes a shot of compressed air in the fluid hole does the trick.
If the pistons aren't too bad you might try some 0000 steel wool, or #600/800 wet-dry sand paper to clean them up. Aside from the usual parts outlets--- Bike Bandit, Mr.Cycles or a wrecking yard ect,ect. You may have to try E-Bay or Honda. Unless some of our Pack-Rat members have a stash of old parts lying around.
"Good Luck"
Hardest part of the rebuild is getting the caliper off the bike, and the piston out of the the bore. Sometimes a shot of compressed air in the fluid hole does the trick.
If the pistons aren't too bad you might try some 0000 steel wool, or #600/800 wet-dry sand paper to clean them up. Aside from the usual parts outlets--- Bike Bandit, Mr.Cycles or a wrecking yard ect,ect. You may have to try E-Bay or Honda. Unless some of our Pack-Rat members have a stash of old parts lying around.
"Good Luck"
