Steve Saunders Goldwing Forums banner
Status
Not open for further replies.
1 - 4 of 4 Posts

·
Premium Member
Joined
·
110 Posts
Discussion Starter · #1 ·
Didn't have any problems undoing the centre nut of the clutch but now that I have put it all back in the clutch centre keeps spinning around so I cannot torque the nut.

The only thing I am not sure on is the position of the cupped washer, does the dished ( curved in side) face in or out? Other than that I can't tell where I have gone wrong. Everything seams to be lined up level.

Any help or suggestions please?
 

·
Premium Member
Joined
·
110 Posts
Discussion Starter · #2 ·
I am a fair dinkum twit! I totally forgot that I put the two springs, bolts and washers on to remove the centre nut.

The only thing I need now is to confirm the position of the cupped washer.
 

·
Administrator
Joined
·
27,923 Posts
The curved in side faces in.
 

·
Premium Member
Joined
·
110 Posts
Discussion Starter · #4 ·
All the best, thanks Dave.
 
1 - 4 of 4 Posts
Status
Not open for further replies.
Top