Steve Saunders Goldwing Forums banner
Status
Not open for further replies.
1 - 7 of 14 Posts

· Premium Member
Joined
·
83 Posts
Discussion Starter · #1 ·
imported post

Hi guys, I've to start with this new topic although there's comments on cruise control before this but I could'nt find the solution yet. My cruise control is not fuctioning and I've check the followings:

a. Both Cruise check 'on' light and set light is working when the ignition switch turn on and goes off after the engine start.

b. During driving the cruise light'on' when press the 'on' switch and remain 'on' until I off.

c. The cruise set light 'on' when I press the cruise set switch and remain 'on' unless I do the following:

(1) Press front brake lever or

(2) Press foot brake or

(3) Press the clucth lever or

(4) Close the trottle.

d. I've check the cable connection betweem actuator to the carburator and it seem working without obstruction.

So I need help from you smart guys in this forums which I thinks the best goldwing forums. Thanks.
 

· Premium Member
Joined
·
83 Posts
Discussion Starter · #4 ·
imported post

Thanks for the replies, I dont thinks it's the micro switch since all the check light functions to every movement of the switch. The vacuum actuator also had been check and it works every time I suck directly from the suction hole. The only thing I've not check whether the cruise valve is functioning. Anyone faced similar problems please advise. Tq
 

· Premium Member
Joined
·
83 Posts
Discussion Starter · #6 ·
imported post

I dont think so, the rear brake function as usual, it will off the set cruise switch whenever I depress the brake padel. Thanks
 

· Premium Member
Joined
·
83 Posts
Discussion Starter · #9 ·
imported post

Yes, both lights set cruise and cruise is on. May be I'll try to wait a little longer for a few seconds for the cruise to kicks in as suggested. Again Tq guys.
 

· Premium Member
Joined
·
83 Posts
Discussion Starter · #10 ·
imported post

Great forums and great guys. Today I managed to engaged the cruise control. I think Mr Dusty is wright, I waited for almost 7 seconds until the cruise start to kicked in. Once the cruise is functioning, no more lags and tried few times. Or may be it was because I replaced new OD bulb which was blown before this. Anyway TQ very much guys.
 
1 - 7 of 14 Posts
Status
Not open for further replies.
Top