Steve Saunders Goldwing Forums banner
1 - 8 of 8 Posts

·
Registered
Joined
·
8 Posts
Discussion Starter · #3 ·
I dont know the last time the belts were changed. I just picked up the bike and it is a 1991 that has been kept in climate controlled storage and only has 10,000 miles. I removed the lower right cover and can see the belt (can only see one side) looks to be in good condition. I turned the motor over by hand and was able to get recreate the noise again....
 

·
Registered
Joined
·
8 Posts
Discussion Starter · #7 ·
I took the covers off and everything looks to be aligned correctly and new belts installed. Any other ideas? I am able to turn the engine over by hand and have now heard it on both sides. When it makes the noise it is not consistent. Potentially a stuck lifter or similar?
 
1 - 8 of 8 Posts
Top