Steve Saunders Goldwing Forums banner

Status
Not open for further replies.
1 - 7 of 7 Posts

·
Premium Member
Joined
·
375 Posts
Discussion Starter #1
imported post

Hi All,

Just would like to know where all of you that have aftermarket faders, have the knobmounted. Tank shelter? Dash?

TIA
 

·
Premium Member
Joined
·
11,739 Posts
imported post

IF YOU TELL US WHAT MODEL WING YOU HAVE MAYBE SOMEBODY CAN ANSWER ..CHEERS CIARAN
 

·
Premium Member
Joined
·
375 Posts
Discussion Starter #3
imported post

DUH, I guess that might help.

1995 GL1500I



TIA
 

·
Premium Member
Joined
·
626 Posts
imported post

On the non CB bikes it's usually on the CB blank panel, or also beside the ignition switch.
 

·
Premium Member
Joined
·
224 Posts
imported post

Mine used to be beside the ignition, a small hole drilled in it for the fader to mount.
 

·
Postpubescent member
Joined
·
36,382 Posts
imported post

There's room for it just aft of the ignition switch, plenty of clearance below there. My 93 has a raised section there with the fader mounted on it's left side but you could mount it flat in the area. Take a look at firecreek's panels if you would like to add a volt meter too.

http://www.firecreekacc.com/wing_panel_plus.htm
 

·
Premium Member
Joined
·
375 Posts
Discussion Starter #7
imported post

Thanks to all that replied. Looks like next to ignition switch.
 
1 - 7 of 7 Posts
Status
Not open for further replies.
Top