Steve Saunders Goldwing Forums banner
Status
Not open for further replies.
1 - 5 of 5 Posts

·
Premium Member
Joined
·
1,581 Posts
Discussion Starter · #1 ·
imported post

is the final drive shaft suppose to come out with hub when you take hub off?

thank you



mark:waving:
 

·
Premium Member
Joined
·
151 Posts
imported post

It can, you will just have to pull it out of the diff. and fish it back in the u joint
 

·
Premium Member
Joined
·
1,581 Posts
Discussion Starter · #3 ·
imported post

MONKEY WRENCH wrote:
It can, you will just have to pull it out of the diff. and fish it back in the u joint
guess i better do some homework... i'm :?but it dont take much t get me there:cheeky1:



i pulled hub and back wheel off bike today....on the back of mtor there is a piece that is suppose to slide back and lock, if you have to pull motor. well, this piece will not budge.

and if i'm thinking right, this shaft runs through the swing arm. i'm thinking this shaft is way damaged and locked onto motor

thank you,



mark:waving:
 

·
Premium Member
Joined
·
1,304 Posts
imported post

On an 1100 the ujoint is secured to the output shaft by a circlip. I'm not sure if this applies to the 1500.
 

·
Premium Member
Joined
·
1,581 Posts
Discussion Starter · #5 ·
imported post

k1w1t1m wrote:
On an 1100 the ujoint is secured to the output shaft by a circlip. I'm not sure if this applies to the 1500.
no, the 1200 and 1500 are spring loaded



mark:waving:
 
1 - 5 of 5 Posts
Status
Not open for further replies.
Top