Joined
·
40 Posts
imported post
I heated up the slider near the seals, used a x acto razor knife to cut the rubber on the edge of the seal being careful not to mar the Aluminun. I put in PB Blaster heated them up more, scraped more, heated more making sure the PB Blaster could get down the sides. than put in the vice and in a few slide hammer pulls out they came. Thanks everyone, I believe the blaster and the heat did it.
I heated up the slider near the seals, used a x acto razor knife to cut the rubber on the edge of the seal being careful not to mar the Aluminun. I put in PB Blaster heated them up more, scraped more, heated more making sure the PB Blaster could get down the sides. than put in the vice and in a few slide hammer pulls out they came. Thanks everyone, I believe the blaster and the heat did it.