Steve Saunders Goldwing Forums banner

Status
Not open for further replies.
1 - 3 of 3 Posts

·
Premium Member
Joined
·
45 Posts
Discussion Starter #1
imported post

My front brakes on my 81 GL1100 are very spongy so I decided to investigate. Upon examining the front master cylinder/resevoir I noticed a bunch of crud in the housing underneath the plastic reservoir.

My question - how does one remove the plastic reservoir to clean out the master cylinder.:baffled: It looks like it is just pressed in there, however, I do not want to cause any unnecessary damage by just prying it off without asking the community of experts first....

I gotta get the crud cleaned out in order to bleed the brakes properly...I rode 150 mile today with poopy brakes:goofygrin:

Thanks

JM Wolfe
 

·
Premium Member
Joined
·
79 Posts
imported post

It will pull out JM. Theres a big O ring underneath and you will need to wiggle the resevoir and pull it up.
 
G

·
Guest
Joined
·
0 Posts
imported post

Hey Marky :waving:Would you please update your profile and complete the LOCATION section and tell us what country you live in. :clapper:

:leprechaun::18red::leprechaun:
 
1 - 3 of 3 Posts
Status
Not open for further replies.
Top