Joined
·
1,594 Posts
imported post
I just replaced my dogbone with a blade type. The wires that ran through the dogbone are 10 ga. and the wires from the new blade type were only 12 ga. Rather than solder the 10 & 12 ga together I took apart the fuse holder and crimped plug ends to the 10 ga already on the bike and inserted them in the fuse holder. The wires that come with the fuse holder are only crimped to the blade receptors as it is so I figure I just eliminated 2 possible weak points (soldered wire on each side of the holder).
I just replaced my dogbone with a blade type. The wires that ran through the dogbone are 10 ga. and the wires from the new blade type were only 12 ga. Rather than solder the 10 & 12 ga together I took apart the fuse holder and crimped plug ends to the 10 ga already on the bike and inserted them in the fuse holder. The wires that come with the fuse holder are only crimped to the blade receptors as it is so I figure I just eliminated 2 possible weak points (soldered wire on each side of the holder).
