[CJ1]

Hi all ,
I have a 1983 Honda GL 1100 Aspencade.
I have a leak from the carb fuel inlet .
I am also able to wiggle it slightly.
When I crank it gas comes out from the carb inlet tube . ( Sorry I don't know the proper name for this part. ) It is the brass barbed fitting on the carb that is fed from the fuel pump.
Can someone please guide me to the best way on how to replace this ?
Any help is much appreciated.
Thank you

 

[DaveO430]

It's a little hard to get to but you can remove it and replace the o-rings.

 

[CJ1]

It's a little hard to get to but you can remove it and replace the o-rings.

Thanks. Any idea where I can buy a Honda replacement or other quality replacement?
So far all I have seen is 90° elbows.
Also , how is it removed ?

 

[DaveO430]

To get the o-rings from honda you have to buy a complete carb kit. There is a screw that holds the accelerator pump linkage and also holds the fitting in, careful and pay attention to how everything goes. You can take the o-rings to a parts store and find something that will work.

 

[CJ1]

To get the o-rings from honda you have to buy a complete carb kit. There is a screw that holds the accelerator pump linkage and also holds the fitting in, careful and pay attention to how everything goes. You can take the o-rings to a parts store and find something that will work.

Followed your advice carbs back in NO LEAKS. And purrs like a kitten. Thank you sooo much Dave for the guidance and knowledge