[tubabone]

imported post

So i finally got all the mounting hardware from the Voyager trike converter kit off of my wing and replaced the centerstand. I was pleasantly surprised how easily it goes up onthe centerstand, but how the heck do you get it off?



My legs are a little too short to get good leveregewhile sitting on the seat. So I can't push it off the stand while on the seat. My old bike would rock back onto the rear tire once I sat on it, so i could just ride off the stand. But the rear tire stays up off the groundeven when I sit on the wing.



So does anyone have any helpful hints or tricks to help get the bike off the centerstand without dropping the thing.



Also, which do you use more, the side stand or the centerstand?



ken k

 

[tubabone]

imported post

thanks everyone for you replies.

Like anything else with this bike i will just have to practice it a bit more to get the technique down. i am a little bit leary trying to take it donw while standing next to the bike. i would much prefer to do it while sitting on it if possible. I iwll have to try the rocking technique.

thanks again for helping a wing newbie! (newingie?)

ken k