Steve Saunders Goldwing Forums banner
Status
Not open for further replies.
1 - 8 of 8 Posts

·
Premium Member
Joined
·
227 Posts
Discussion Starter · #1 ·
Hello,
I am looking at heads off the 81 GL1100 and off the 83" Aspencade
Seems the Intake Valve off the 81' (OEM Part number 14711-371-000 ) is different then the 83' ( OEM part number 14711-MB9-780 )
Anyone by chance know what the difference is other then the OEM number ?

Just wondering if I have to take the 81' valves out and replace them with the 83's ( Installing the 81 heads in an engine with the 83' Crank shaft)

Thank You !
 

·
Official "Cheeky Plonker"
Joined
·
1,230 Posts
)@mn man, you ask the most difficult questions, you really are testing this forum.

I'm right behind you dude, keep on goin' fella, I like this $#!t.
 

·
Premium Member
Joined
·
227 Posts
Discussion Starter · #3 ·
Hello Chilidawg,
I try to do all the research I can on some of this stuff, When I come to a road block is when I bug all you smart riders.. hehe
 

·
Administrator
Joined
·
27,951 Posts
I don't think there is any difference other than the part #. All the specs are the same.
 

·
Premium Member
Joined
·
759 Posts
They have different valve stem keepers. I don't remember which has wich but the valves interchange in the heads.
 

·
Premium Member
Joined
·
227 Posts
Discussion Starter · #6 ·
ok Dave ..We know that for sure ?
Would be nice to not have too chance the valve , don't want it to hit the piston ( long stem )or not open long enough\too long is my fear ..
 
1 - 8 of 8 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Status
Not open for further replies.
Top