Steve Saunders Goldwing Forums banner

Status
Not open for further replies.
1 - 2 of 2 Posts

·
Premium Member
Joined
·
472 Posts
Discussion Starter #1
imported post

remove the speaker cover. back screws out holding speakers about halfway. just the screws next to the inst. cluster. put masking tape in area of screwson back of speaker cover. gently put cover back on and press it against the screws. this should mark the masking tape. drill cover. replace screws with screws a little longer, they are going through the cover. replace cover,use screws to go through the cover and screw into the brackett that was holding the speaker. stainless allen head srews look good. i have two 1200s and have repaired them both because the taps are broke. regards walkabout :)
 
1 - 2 of 2 Posts
Status
Not open for further replies.
Top