Steve Saunders Goldwing Forums banner
Status
Not open for further replies.
1 - 5 of 5 Posts

·
Premium Member
Joined
·
7 Posts
Discussion Starter · #1 ·
imported post

I have to ask to ease my mind. I removed the rear drive unit on the gl1100 when I installed a new rear tire. I greased the rear shaft spline and applied the same grease on the gear cogs in the drive unit. I put new gear oil in the unit. My question does it matter what type of grease you apply to the gear cogs or spline in the drive unit.
 

·
Administrator
Joined
·
27,952 Posts
imported post

It should be MOly paste, 60% moly. Other lubes will work but won't last long.
 

·
Premium Member
Joined
·
7 Posts
Discussion Starter · #3 ·
imported post

Thanks for the info. getting ready to take a long trip. I will remove the drive unit again and apply the molly paste.
 

·
Postpubescent member
Joined
·
36,382 Posts
imported post

Honda Moly 60 or Loctite Moly Paste at 65%, the only way to protect the splines!
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Status
Not open for further replies.
Top