Steve Saunders Goldwing Forums banner
Status
Not open for further replies.
1 - 1 of 1 Posts

·
Administrator
Joined
·
28,209 Posts
Try getting the gage between the cam and the fallower?
That would be fine except the clearance will be different, the rocker arm is not 1 to 1. One could check the clearance at the cam end on a known good one and use that measurement. Or adjust one that is good and observe the amount of turn it takes for the screw to contact the valve head from there and adjust the rest the same.
 
1 - 1 of 1 Posts
Status
Not open for further replies.
Top