Steve Saunders Goldwing Forums banner

Status
Not open for further replies.
1 - 5 of 5 Posts

·
Premium Member
Joined
·
2 Posts
Discussion Starter #1
imported post

can't see where this o ring in the aircut off valve kit gos on my 84 1200 also is there any thing I should do now that I have it apart other than replace kit parts and the manifold o rings?

thank you

Ken
 

·
Piled Higher and Deeper
Joined
·
4,513 Posts
imported post

I've forgotten exactly, but in either the cap you take off or the body to which the cap screws, there is a small hole into which it fits to seal the parts.. probaby vacuum..
 

·
Premium Member
Joined
·
2 Posts
Discussion Starter #3
imported post

Thanks for your reply I looked and looked this kit must be used for another bike that needs it.
And to answer your question about the forest you’ll find out after she clear cuts it
 

·
Premium Member
Joined
·
9,790 Posts
imported post

KBEN wrote:
can't see where this o ring in the aircut off valve kit gos on my 84 1200 also is there any thing I should do now that I have it apart other than replace kit parts and the manifold o rings?

thank you

Ken
Welcome to this Great Site!

Pull up a chair and join on in!

Ride Safe, Ray


:waving:
 

·
Piled Higher and Deeper
Joined
·
4,513 Posts
imported post

KBEN wrote:
Thanks for your reply I looked and looked this kit must be used for another bike that needs it.....
Could be.. I was answering from a GL1100 standpoint.. I always get introuble with the 1200..
 
1 - 5 of 5 Posts
Status
Not open for further replies.
Top