Joined
·
44 Posts
Mine was leaking so I tried staking it with a socket (worked on the front brake master) and I broke the window. I read somewhere that someone makes replacements, would any of y'all know?
John
John
GL1200 clutch master cylinder "window"
- Status
1 - 6 of 6 Posts
Joined
·
3,391 Posts
Try here http://www.newrivercyclesalvage.com/
Joined
·
21 Posts
I second that...
I got (2) From www.newrivercyclesalvage.com/.
They worked out great. Just make sure the hole is really clean and apply some clear RTV with a toothpick around the outside edge and don't glob it.
I got (2) From www.newrivercyclesalvage.com/.
They worked out great. Just make sure the hole is really clean and apply some clear RTV with a toothpick around the outside edge and don't glob it.
Joined
·
44 Posts
Thanks for your replies, Dublin, VA is a 70 mile road trip from me, sounds like a CBX cruise!
1 - 6 of 6 Posts
- Status
Join the discussion
Recommended Reading
-
Wiring Pulse gen. pickups from 1984 to a 1985
Goldwing Technical ForumSo I've had to find another motor for my 84 interstate. Problem is the 84 had the pickups are on the rear case and the 85 has them on the front of the crank. In order to wire it I have to move the connector to the front and the color code doesn't match up right ? There is a white with black...- 32
- 291
-
Stevensacc · updated
-
"the Hunley", or pidjones needed a project
Goldwing Technical ForumI will leave it to the reader to check the thread (www.goldwingfacts.com/forums/2-goldwing-technical-forum/424137-new-gl1000-project-first-big-problem.html) that I previously started (in 2013) about this project. I got side-tracked by life, but am now retired and have been beating on the old...- 72
- 5K
-
pidjones · updated
-
1984 aspencade suspention system
Goldwing Technical ForumVery clean bike for her age.Im going through the brake rebuild now. I have an onboard air system that seems to not be working.The suspension is at issue for the air ride.Is it worth a look into restoring it or is it better to just convert to progressive?- 1
- 53
-
1986 GL1200 Aspencade turn signals won't work
Goldwing Technical ForumI replaced my steering head bearings and after reassembling the bike, the turn signals now do not work. To do this job I removed the fairing, handlebars, steering stem, turn signal cancel control unit, etc. My first guess was that I had just forgotten to plug something in. I discovered that in...- 3
- 94
-
87 gl1200 carb woes
Goldwing Technical ForumHave an 87 gl1200 that sat about 5 years. Carbs were green inside. Cleaned jets, replaced needle valve and seat, readjusted the float, put back in. Started up right away with some choke. Will idle with half choke, but if I take choke off, it'll stall. Also doesn't want to take throttle either...- 8
- 150
-
gos · updated
Join now to ask and comment!