Steve Saunders Goldwing Forums banner
Status
Not open for further replies.
1 - 2 of 2 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
I just put a new stator in my 87 Interstate, I decided to do the job myself, Now that I have everything back together, I have no pressure on my clutch, I have tried the master cylinder bleed, I can't get any bubbles, I tried bleeding at the slave cylinder...nothing changes. The clutch lever has no pressure it just "flops":wtf: Could I have a bad slave cylinder? :?Did I miss something putting it back together? Or do I need to keep bleeding the line....I am :lash: HELP!
 

·
Registered
Joined
·
2 Posts
Discussion Starter · #4 ·
I put a tube on the bleed valve at the slave, and sucked on it.. made sure fluid level was still good, pulled off tube and tightened valve, then I bleed it at the banjo bolt at the cylinder...it worked!!
 
1 - 2 of 2 Posts
Status
Not open for further replies.
Top